|
Tapared roller bearings are specially suitable for carrying important axial and radial forces acting simultaneously.
Those bearings are detachable and make possible a separation of the outer
ring from the inner ring with rollers. (Fig. 1)
Generators of the raceways converge in a common point over the rotation shaft of the bearing.
This allows to assure a roller movement without any rollers slidings over
the raceways. (Fig. 4)
It can change the relation between the axial and radial load bearing capacity
based on the angle that formed the raceways with the shaft of bearing. (Fig.
2 and 3)
Those bearings are used in pairs and their mounting must be regulated in
order to obtain the necessary clearance (preload) for an optimum functioning.
(Fig. 5)
Additional possibilities between those bearings and another ones:
- High capacity of radial and axial load combined.
- Easy assembling and disassembling because of its separable type.
- Lower friction coefficient and higher working speed than another type of roller bearings.
Our bearings have a better performance when outside pollution agents due to the camber effect of the lubricant in its use.
|
C/
Bari, 18 | 50197 Zaragoza (Spain)
+34
976333850
+34
976348935 comercial@fersa.com